Turbo manifold design.
justin ivan
vlkslvr at hotmail.com
Wed Jan 10 18:29:28 GMT 2001
I't not familiar with Hugh McInnes but the idea of a slip joint is
appealing, my only question is how to keep them from leaking? Bellows would
solve this problem but could be difficult to produce.
Justin
>From: "Bruce Plecan" <nacelp at bright.net>
>Reply-To: diy_efi at diy-efi.org
>To: <diy_efi at diy-efi.org>
>Subject: Re: Turbo manifold design.
>Date: Wed, 10 Jan 2001 11:34:40 -0500
>
>I like Hugh McInnes's way.
>Particully if using short tubes, then use sleeve fitting of the tubes (or
>bellows).
>If long primaries not as critical.
>Individual flanges, given a few thousand heat cycles can be about
>impossible
>to line up.
>Again, no universal rules about what's best.
>Bruce
>
>----------------------------------------------------------------------------
>To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
>quotes)
>in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org
More information about the Diy_efi
mailing list