off topic / traction control

[Programmer]

Thanks Ludis !! Was beginning to think noone talks to me anymore <g>...

Lyndon.
----- Original Message -----
From: Ludis Langens <ludis at cruzers.com>
To: <diy_efi at diy-efi.org>
Sent: Friday, January 19, 2001 12:59 AM
Subject: Re: off topic / traction control


> Programmer wrote:
> >
> > Happen to have a list of the "plug and plays" ??
> >
> > >Some of the stuff is really amazin for the plug and plays
> > >165s to 747s can be just a couple wires off.
> > >the late caprice is a P+P with a 747
> > >Couple other TBIs too.
> > >Bruce
>
> The 24+32 pin C3 dual injector TBI ECMs should all be plug and pray,
> except perhaps for some accessories.
>
> The single injector 24+32 pin C3's should also be identical in their
> group.  The '165 P4 matches this group - and indeed GM briefly used it
> in place of one of these C3's.
>
> The 24+32 pin port injection C3's are similar (though not 100%
> identical) to each other and the previous two groups.
>
> All the carb ECMs might be similar.  I haven't checked actual pinouts,
> but they seem to use the same plugs.
>
> About the only C3's which don't have much compatibility are the edge
> card based single TBI ECMs.
>
> --
> Ludis Langens                               ludis (at) cruzers (dot) com
> Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
>
> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org