spark timing measurement and recording

[Moofaloof at aol.com]

Yes, exactly.  I use a Fluke 97 scopemeter and pick off the crank trigger signal and the signal to the coil on DIS cars or use an inductive pickup on the plug wire.
jc




In a message dated Wed, 7 Mar 2001 11:37:10 AM Eastern Standard Time, Ira Emus <ira at CamaroElectronics.com> writes:

<< At 08:21 AM 3/7/01 -0500, you wrote:
>Has anyone used any equipment to actually measure and record ignition timing
>at the engine.

I have a Fluke Model 98 scopemeter that will do this if there is a TDC 
crank pickup. Can't imagine it would be that hard to rig up a pickup if you 
had the meter or something similar.

Ira

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org

 >>


----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org