DIY_EFI megasquirt

[Bruce Bowling]

MegaSquirt can be run in open-loop mode - in fact I have not fully tested 
the closed loop mode so right now I am only running my engine in open 
loop.  To turn off the closed-loop mode, set the O2 step delta to zero - 
this will inhibit the automatic stepping of the mixture.

One more point: with the tuning page and the O2 gauge (see the PC 
Configurator screen shots at the megasquirt web site) I can tune each grid 
point with the O2 reading. In fact, I recommend one to install an O2 sensor 
even if they plan on running in open loop mode - the feedback one gets 
while tuning is invaluable.

- Bruce


>------------------------------
>
>Date: Sun, 11 Nov 2001 12:51:42 -0500
>From: "Clare Snyder" <claresnyder at home.com>
>Subject: Re: DIY_EFI megasquirt
>
>Can the Megasquirt be run without the O2 sensor?
>- ----- Original Message -----
>From: "DIY_EFI Digest" <DIY_EFI-Digest-Owner at diy-efi.org>
>To: <DIY_EFI-Digest at lists.diy-efi.org>
>Sent: Sunday, November 11, 2001 4:00 AM
>Subject: DIY_EFI Digest V5 #874
>
>

- Bruce

---------------------------------------------
              Bruce A. Bowling
          bbowling at earthlink.net
    http://home.earthlink.net/~bbowling
---------------------------------------------

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org