Airflow meter discussion

[Howard Chu]

>From all the previous discussion, I gathered that in a flapper type (or in
my case, Measuring Core Volume Air Flow) meter, the flap displacement is
proportional to the difference in pressure between the front and back of the
flapper. The obvious solution then: why not remove the meter, and use two
pressure sensors instead, one before and one after the throttle body? Given
the throttle body dimensions, all you need is to convert the pressure
difference to density, multiply by throttle body volume and you have mass.
No additional flow restrictions, and no VE curve mapping required.

  -- Howard Chu
  Chief Architect, Symas Corp.       Director, Highland Sun
  http://www.symas.com               http://highlandsun.com/hyc
  Symas: Premier OpenSource Development and Support

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org