WB O2 Sensor Connector Again

[Neil.Poersch at mts.mb.ca]

Bruce,

Thanks for the confirmation.

 FYI ,  I could not source locally a 1% resistor but of course could order
a batch of 100 resistors and pay shipping and wait a week or two for
delivery. So I did what our primitive ancestors did at the beginning of the
Industrial Revolution and implemented the methodology of "selective fit".
I got out my collection of 5% tolerance resistors, measured them with my
DVM and found one to match within 0.1 % of the original calibration
resistor.

Neil

>
Mounting a same value resistor on the board will work
just fine; 1% is more than accurate enough, since it is
just a gain trim to begin with.  The disadvantage is you
need to change the resistor if you switch to another
sensor.

Bruce Roe
<




----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org