WB O2 sensor connection alternative

[Timothy J Burgess]

An alternative method of sensor to harness connection is to use multipin
automotive weather pack connectors.  Assuming that a discrete, or
combination of discrete, resistors is used to emulate the sensor
calibration resistor, the original connector may be cut from the sensor
harness, and the sensor wires may be soldered to the weather pack connector
pigtails.  Pep Boys has inexpensive 3 pin and 2 pin male & female mating
connectors with pigtails available to make the required 5 wire sensor
connection.  They also stock more expensive 6 pin male & female connectors
with pigtails, if that better suits your application.

Tim

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org