Cam position sensing w/o a cam sensor

[Ludis Langens]

Santi Udomkesmalee wrote:
> 
> I don't see why one needs to sync the cam to the flywheel more than once,
> but if you guys have some good reasons, I'd like to hear them.

Glitches happen.  Eventually you'll miss a crank reference - or noise
will create a phantom reference.  At that point you'd be out of sync
until the engine is shut down.  If you were to resync at every chance,
you'd be back to normal within two crank revs - and the out-of-sync
event would seem like a misfire.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/


----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org