diy-wb-heater limiter resistor

[Camden Lindsay]

Hello all-
a couple of questions--
Last night i was going over the schematics (is that what they're called?) 
and the emails i had printed out about the diy-wb.

    Bruce, i see that you added 3 15ohm resistors to the limiting circuit as 
you said "total measured 9 ohms"-- is this the total value that goes in that 
resistor space, or is this the total value you added?

(i thought the formula was 1/R=1/R1+1/r2, etc etc... figuring to an add of 5 
ohms)

-- which resistor # is this on the board?  looking at the schematics 
(although i'm just a beginner) I was guessing it is # 4.. but that resistor 
is already quite low (r<1 ohm) ....  Is this the correct resistor #?

also, you had no problems using this low of a resistance (crinkle noises as 
someone else mensioned)?

If i am repeating any info already covered, i apologize-- i have read all of 
the mailings since i've been part of the list- but i may have missed 
something...

Thank you!

Sincerely
Camden Lindsay



_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org