Somewhat related to EFI

[Tom Sharpe]

10/4 to Greg. Go to http://www.mtco.com/~twsharpe/images/Piston2.jpg

Greg Hermann wrote:

> At 8:20 PM 10/12/01, Seth wrote:
> >It makes sense to me. 0.001" is on the tight end of the scale for a SBC
> >in my opinion. So 0.002" sounds pretty good to me. As long as it isn't
> >0.0028" rounded down.
> >
> >-Seth
>
> Not to mention that the engine would likely be a lot better off with forged
> pistons (of 4032, the low expansion alloy) with .002" clearance than with
> hyperyoujunkits !
>
> Greg

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org