Somewhat related to EFI

[Bruce]

Was a huge sigh, from the lil guys as that page downloaded,  then with
moistened cheeks they slowly walked away.   They always find the death of an
engine tragic.
Bruce
   Found Doc walking to the GN with a bumper sticker that I had to take away
form him.  Said *hold my beer, and watch this*....



----- Original Message -----
From: "Tom Sharpe" <twsharpe at mtco.com>
To: <diy_efi at diy-efi.org>
Sent: Saturday, October 13, 2001 11:20 PM
Subject: Re: Somewhat related to EFI


> 10/4 to Greg. Go to http://www.mtco.com/~twsharpe/images/Piston2.jpg
>
> Greg Hermann wrote:
>
> > At 8:20 PM 10/12/01, Seth wrote:
> > >It makes sense to me. 0.001" is on the tight end of the scale for a SBC
> > >in my opinion. So 0.002" sounds pretty good to me. As long as it isn't
> > >0.0028" rounded down.
> > >
> > >-Seth
> >
> > Not to mention that the engine would likely be a lot better off with
forged
> > pistons (of 4032, the low expansion alloy) with .002" clearance than
with
> > hyperyoujunkits !
> >
> > Greg
>
> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org