Sportsman 2 heads

[elcamino73]

I am doing the same on my AFR heads and I won't be doing the deck.
----- Original Message -----
From: "Dan Zorde" <dzorde at erggroup.com>
To: <diy_efi at diy-efi.org>
Sent: Monday, October 22, 2001 3:29 PM
Subject: Sportsman 2 heads


> Hi All,
>
> My Sportsman 2 heads finally arrived, got a reasonable deal as well I
> think ($760 for the pair and free delivery).  Since this is going on a
> TPI setup is it worthwhile cleaning up the ports and chambers to a
> slightly smoother surface than the cast looking finish ?
>
> My understanding is that since it is a dry system (fuel not entering air
> stream until valve area) then ports should be smooth and for minimum
> detonation try and remove all sharp edges and rough surfaces in the
> chambers.  Do you also smoothe the edge of the deck surface to the
> chambers ?
>
> Cheers
>
> Dan  dzorde at erggroup.com
>
> ---------------------------- ERG Group --------------------------
>  The contents of this email and any attachments are confidential
>  and may only be read by the intended recipient.
> -----------------------------------------------------------------
>
> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org