Jeep MY 2000 ECM pinouts needed.

[Bruce]

By buying a shop manual, I did not infer to shoplift it.
Bruce


----- Original Message -----
From: "Peter Gargano" <peter at techedge.com.au>
To: <diy_efi at diy-efi.org>
Sent: Thursday, October 25, 2001 3:51 AM
Subject: Jeep MY 2000 ECM pinouts needed.


> As I mentioned a post or two ago, I have a MY 2000 Jeep Cherokee ECM.
> It has been pointed out to me that perhaps the Cherokee name is not
> used in the US anymore (where the ECM was pulled).
>
> Anyway, I'm still trying to find the pinouts for this ECM. Here are
> some numbers on the ECM:
>
> MOTOROLA S/N 6A729DQGJ9T
> CHRYSLER P/N P56041                     635AF
> MODULE S/N TEM2059QGJ9T
>
> This label is over another label with a 634AE label (probably reflashed
> software).
>
> The ECM is in a cast box about 210 x 140 x 20 mm with a flat plate top
> and three 32 pin connectors mating to a Black, a White and a Grey plug.
>
> I'm really just after enough info to connect this ECM to power,
> ground, and the OBD connector. Can anyone help?
>
> Peter.
> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org