DIY-WB construction question

[Brian Renegar]

>The plug on the sensor is actually an 8 pin unit. 5 are used for the heater
>and sensor, 1 is blanked off, and the last 2 are where the cal resistor is
>located. It works. Mark


Ok, so the cal resistor is located in the connector?  Then what is the 
silver crimped cylinder on the wires in this picture: 
ftp://diy-efi.org/pub/diy_efi/project_files/diy_wb1/wb-sensor.jpg  I 
thought that's where the resistor was located.

Also, can the resistor be moved from the sensor to the board, or is it just 
better to run all 7 wires out to the sensor?

Thanks,
Brian

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org