sensor datasheet

[Stewart Prince]

That's it.  It contains the "typical" wire hookup, etc. as well as the air fuel
ratio vs voltage for the ntk with their controller.  The curve fit is the red
scribble on tip.

Eric Fahlgren wrote:

> Stewart Prince wrote:
> >
> > Yaz
> > I posted an acrobat file of some NTK sensor info on the FTP site a couple of
> > months ago.  I believe it was labeled "NTK."
> > S. Prince
>
> Is this it?
>
>    ftp://ftp.diy-efi.org/incoming/NTK_uego.pdf
>
> (About 3.9 meg.)
>
> --
> Eric Fahlgren                            Mechanical Dynamics, Inc
> efahl at adams.com                          Ann Arbor, Michigan, USA
> ----------------------------------------------------------------------------
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org

--
STEWART PRINCE

PROFESSOR, MECHANICAL ENGINEERING

CALIFORNIA STATE UNIVERSITY, NORTHRIDGE


----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org