DIY-WB... It's alive...

[David Hunt]

You are correct.

dh
----- Original Message -----
From: "terryk" <terryk at foothill.net>
To: <diy_efi at diy-efi.org>
Sent: Monday, September 03, 2001 9:15 AM
Subject: Re: DIY-WB... It's alive...


> If you disconnect the sensor, the pin reads 450mV, right? This means the
> bias is from the ECM.
>
> Correct me if I'm wrong.
>
> ----- Original Message -----
> From: "rr" <RRauscher at nni.com>
> To: <diy_efi at diy-efi.org>
> Sent: Monday, September 03, 2001 7:06 AM
> Subject: Re: DIY-WB... It's alive...
>
>
> >
> > The general consensus has been that the ECM applies the bias. I have
> > not found any evidence of this. Maybe some ECMs do. My belief is
> > that the sensor that generates this voltage.
> >
> > BobR.
> >
>
> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>


----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org