Bolt on Throttlebody suggestions

[Matt Cramer]

At 12:39 AM 9/23/2001 -0400, Alan Barrow wrote:
>Hello all,
>
>Despite me earlier query on mounting Kjetronic injectors, I am also looking
>for for small and inexpensive TBI bodies for my project. Currently it uses
>dual 36mm 2bbl Zenith 36NDIX carbs. It also could utilize a Weber DCNF.
>(both are 52x85mm rectangular flange)

[snip]

>All suggestions would be welcome.
>
>Thanks,
>
>Alan Barrow
>

	Hmmm... this may be a little on the large side, but how about the Chrysler
2.2 or 2.5?  Some of their non-turbo versions used TBI systems.  However,
these are large enough that I've heard of trying to use two of these to
feed a V8 with a tunnel ram like setup, so two of them would probably be on
the large side for a four-banger.

Matt Cramer
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org