Modifying/fabricating manifold for injectors?

[Dave Williams]

-> Does anyone have suggestions for mounting  mechanical (K-jectronic)
-> injectors in an existing manifold? Or even a fabricated manifold?

 I used pieces of 3/4" aluminum round bar with holes drilled through.
I don't remember the size, probably close to 3/8".  I was going to use
O-rings to seal the nozzles, but figured some RTV sealer would probably
work better.

 I never got any farther than that.
                            
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org