[Diy_efi] 1984 Corvette ECM
rr
RRauscher at nni.com
Thu Aug 29 02:52:46 GMT 2002
Quite a few folks go with the common 1227747 ECM. Found in
many TBI trucks. Can also go with the 1228746 ECM. Found in
some TBI cars. Both drive two P&H TBI injectors. Both have
commented disassemblies available.
Either is a good step up from the '82-'84 ECM.
BobR.
Chuck Kahler wrote:
>
> I installed an 1984 Corvette engine and 700R4 trans in a small British
> sports car. I used the complete TBI setup. It worked great till I was
> charging the battery the other day and started the car with the charger on.
> It started as normal, but after a few seconds, it stalled. Which was
> strange since it never did that before. It would not restart. When trying
> to restart, I notice no spray from the injectors. After extensive testing,
> it was determined a couple of the transistors in the ECM were fried. One
> was on the power supply side and the other was a small one in the main board
> of the computer.
>
> My question has to do with what ECMs will work with this engine/trans. The
> ECM I have is a 1225550. I think it's out of a 1982 Camaro but not sure.
> The correct ECM for the engine/trans is a 1226026. The Chev dealer gave me
> a list of what cars use the 1226026 ECM. Does anyone know what car the
> 1225550 came out of and what cars use the same ECM.
>
> Also does anyone have one they want to sell that would work on my engine or
> know where I can get one. I'm on a budget and don't want to pay much for
> this part.
>
> Thanks for the help,
> Chuck
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi
More information about the Diy_efi
mailing list