[Diy_efi] RE: Timing and dyno pulls
Shannen at grolen.com
Shannen at grolen.com
Thu Dec 19 21:20:13 GMT 2002
I'm away from the house. The format of this message will look
bad. You put that kind of heat to the cylinder heads for less than 12
seconds. Do you think you would have the same good luck for a longer
period of time?
I>On Thu, 19 Dec 2002 14:01:39 -0500
DI> "A6intruder" <A6intruder at adelphia.net> wrote:
DI>> I never heard much
DI>>after reading that
DI>>article but the think supposedly ran great, like your
DI>>melt-down Eclipse but
DI>>longer.
DI>I should mention that I didn't melt anything. :) The
DI>block was fine, the pistons were fine, so was the head.
DI> But I had 73psi compression in cylinder 4 due to the head
DI>gasket. :)
DI>Josh
DI>_______________________________________________
DI>Diy_efi mailing list
DI>Diy_efi at diy-efi.org
DI>http://www.diy-efi.org/mailman/listinfo/diy_efi
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi
More information about the Diy_efi
mailing list