using an analong meter for diy-wb

[bcroe at juno.com]

That will work, if the meter uses less than a half dozen ma.
If the meter input impedance is less than about 200,000 
ohms, you might want to reduce R15 to zero.

Bruce Roe

On Mon, 11 Feb 2002 19:18:14 -0500 "Enzo" 
<enzo5555 at yahoo.com> writes:
> what do you guys think of using an analog meter for 
> the diy-wb?  I can get an 0-3Vdc analog meter and 
> relabel the voltage to the actual a/f ratio and it could 
> be easier for tuning. Just wanted to know if any of guys 
> have done this before and if it works ok..

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org