Tach conversion
bcroe at juno.com
bcroe at juno.com
Tue Feb 19 21:56:55 GMT 2002
Every tach I've seen had a 6/8 adjustment on it. If not,
maybe you could put a low value resistor in parallel
with the coil (it uses a single coil with 2 terminals,
right ?) to make it read lower.
Bruce Roe
On Fri, 15 Feb 2002 17:39:10 -0800 "Whit Hickman"
<whickman at peoplepc.com> writes:
> Is there an easy way tweak a 6 cylinder tach to synch
> with an 8 cylinder motor? My tach is currently indicating
> 8 RPM for every 6 the motor is running and it seems
> there should be an electrical device that would
> convert this.
> Whit
----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org
More information about the Diy_efi
mailing list