fuel pressure sensor

[Stewart Prince]

For some reason, my emails aren't making it to the diy site.

For calibration:
http://www.motorola.com/ies/AIEG/ips.html

Someone at Ford sent me this info...

Looking at the transducer from left to right FTPT
signal, signal return, vref

I'm assuming one must view the sensor from the connector viewpoint for it to
make sense.
S. Prince

Bruce wrote:

> Care to share any details of how they are wiring them up?.  (maybe a
> diagram?)
> Bruce
>
> From: "Stewart Prince" <sprince at csun.edu>
> Subject: fuel pressure sensor
> > All new Ford fuel injection systems are returnless and use a fuel pressure
> > sensor.  The pump is dead-headed.  They cost about $50.  Try (maybe) a
> 1998
> > Escort Zx2.  As far as the calibration goes, I believe Motorola produced
> the
> > sensor and the cal is available on their web site.  If you cannot find it,
> let
> > me know.  I have some students using this sensor at the present time.
> > Many of the new sensors and systems are discussed in the new book
> "Automotive
> > Electronics and Computer Systems" by Robert Brady.
> > STEWART PRINCE
>
> ----- End of forwarded message from owner-diy_efi at diy-efi.org -----
> ----------------------------------------------------------------------------
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org

--
STEWART PRINCE

PROFESSOR, MECHANICAL ENGINEERING

CALIFORNIA STATE UNIVERSITY, NORTHRIDGE


----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org