Is there a classified page for diy-efi?

[mike beebe]

the caprice body style cars with t.b.i. used the same brackets as the 
camaro. junk yards are a good source for the brackets.


From: "Jacob Kooser" <jake_k at attglobal.net>
>Reply-To: diy_efi at diy-efi.org
>To: "Diy Efi" <DIY_EFI at lists.diy-efi.org>
>Subject: Is there a classified page for diy-efi?
>Date: Tue, 19 Feb 2002 07:02:32 -0500
>
>I'm looking for a set of serpentine belt brackets from a camaro for my
>suburban TPI swap.  I've got a serpentine belt system right now - off a '91
>truck.  The problem is, trucks didn't have an air intake "front & center"
>like the TPI will.  I've decided against trying to get just the passenger
>side bracket, which would move the idler - the problem with the truck
>brackets.  I also don't want to have to get a non-standard belt length.  I
>think it's easier to go with the camaro setup and just use the camaro belt,
>minus the air pump - well documented on thirdgen.org.  Anybody know where I
>can source a setup?  Ebaymotors came up dry.
>
>Jake Kooser
>
>----- End of forwarded message from owner-diy_efi at diy-efi.org -----
>----------------------------------------------------------------------------
>To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the 
>quotes)
>in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>


_________________________________________________________________
Join the world’s largest e-mail service with MSN Hotmail. 
http://www.hotmail.com

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org