thermocouple wiring

[Peter Florance]

That makes sense so you don't end up with new junctions in series with your sensor junction


Peter Florance

-----Original Message-----
From:	bcroe at juno.com [SMTP:bcroe at juno.com]
Sent:	Wednesday, January 02, 2002 8:42 PM
To:	diy_efi at diy-efi.org
Subject:	thermocouple wiring

If I remember correctly, the 2 wires are of different 
metals, and you should continue the same metal 
to extend each lead.  Bruce Roe

On Mon, 31 Dec 2001 20:41:06 -0800 "Rob F" 
<rncfiles at hotmail.com> writes:
> Hi all,
> 
> I need to extend the wires on my EGT probe and I 
> remember reading somewhere that the wire has 
> to be a certain ohms/foot for the thermocouple to 
> be read properly.  Did I just make this up in my 
> sleep or is this real?  


> -Rob

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org