Measuring air flow

[Eric Fahlgren]

Greg Hermann wrote:
> 
> At 11:39 AM 1/24/02, Greg S Larson wrote:
> >He said per hour
> >
> >On Thu, 24 Jan 2002 07:30:32 -0500 Eric Fahlgren <efahl at adams.com>
> >writes:
> >> 944Technologist wrote:
> >> >
> >> > I am looking for a bench setup capable of measuring air flow of up
> >> to 500
> >> > m"/hr accurately. Within 1% anyway. Use will be calibration check
> >> of AFMs.
> >> > What kind of gauges are out there that won't cost an arm and leg.
> >>
> >> Do you have your units right?  500 m^3 is over 17,000 cfm (good
> >> for roughly 12,000 HP).
> 
> Mind your units, Eric !! :-)
> 
> That was 500 M^3/_HOUR_--or about 293 cfm !!

Ah, that's better.  Now I think it's not big enough. :)

-- 
Eric Fahlgren                                           Mechanical Dynamics, Inc
efahl at adams.com                                         Ann Arbor, Michigan, USA

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org