[Diy_efi] IAC Motor Question...

[Bruce]

Just match the colors.
Bruce
    Happy 4th,
    lil guys are having a small riot, they were out skiing with the boat
earlier, and generated enough dust the troopers couldn't find them.    And,
they had gotten word about M Stewart's problems, and didn't invite her.




----- Original Message -----
From: Ne14RoxCJ at aol.com
To: diy_efi at diy-efi.org
Sent: Thursday, July 04, 2002 11:14 AM
Subject: [Diy_efi] IAC Motor Question...


Hello all, I'm new to the list and am working on a TBI setup in an '85 K-5
Blazer. Should be simple, but I had to go and make it complicated. I'm using
an old Pro-Jection TB that never had an IAC motor (just the casting for
one). I chose the flange type IAC for ease of machining. The '747 harness I
got was for the threaded type IAC. The problem I have is with the
connectors. The flange type uses a 4-pin Metri-Pack and the threaded type
uses a square 4-pin Weather-Pack. The connectors have the same color wires
(green/black, green/white, blue/black, blue/white), but they are in
different positions. So do I match the wire colors or the positions (A,B,C,
and D)?? Someone please help, as burning up an ECM would not be a good start
for me.

Thanks in advance,
Beau Blankenship


_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi