[Diy_efi] Re: diywb tests

[rr]

I did not see the original post. I think that nigel is referring to the
integrator tests of the controller.

If so then your results are OK. That test is not well designed.

Good luck and have fun with your DIY-WB.

BobR.


Phil Hunter wrote:
> 
> > hi,
> > I just completed my diy-wb! it was my first time soldering a circuit, it
> > was actually pretty fun and i learned quite a bit. Thanks to everyone
> > that made it possible!
> >
> > All the tests passed except the last one (using a 220ohm) i got the
> > start and final voltages right, but it only takes 40 seconds instead of
> > a minute & 15sec. should i be concerned? what could be wrong?
> >
> > -nigel.
> >
> 
> I didn't see a reply, perhaps due to the distracting, um, "discussion"
> going on over on the efi-332 list among the experts, so I'll take a stab
> at it, but I won't claim expertise w/ the circuit. My intuition is
> you're
> okay, I think the RC curve is set in the Heater control circuit, as the
> start and ending voltages get closer together, the time it takes will be
> shorter altho' I wouldn't expect 50% shorter. If you've put any 15 ohm
> resistors across the 1 ohm, you might remove them one at a time and
> retest.
> 
> BTW, congrats on having the guts to give it a go, glad to hear it.
> 
> regards,
> philh
> (digest)
> 
> _______________________________________________

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi