[Diy_efi] Microcontrollers For use on DIY_EFI Systems

[Kent Martin]

Whoops,
I must admit I haven't read much on it yet,
but the M16C/62 has 20 K ram and 256 K flash,
I'm planning on using about 12K of ram for tables!
Kent.
----- Original Message -----
From: "Ville Vartiovaara" <vvartiov at cc.hut.fi>
To: <diy_efi at diy-efi.org>
Sent: Wednesday, July 17, 2002 7:55 PM
Subject: Re: [Diy_efi] Microcontrollers For use on DIY_EFI Systems


> On Wed, 17 Jul 2002, Kent Martin wrote:
>
> > for map tables, else use the internal ram, I think they both have about
12 K
> > ram.
> I'm currently using the Texas' MSP430F149, which is the 'biggest' one, and
> has 60kB Flash and 2kB RAM. So the ram isn't much. Anyway, the flash can
> be updated in-system, and also the code itself can update it while
> running, so the maps can be altered easily, if it's not frequent
> (Flash wears)..
> It's not running as an EFI controller, but the ion sensor, but anyway..
>
>
> -------------------------------------------------------
> Ville Vartiovaara    Ville.Vartiovaara at hut.fi
>  Helsinki University of Technology
>  Dept. of Electrical and Communications Engineering
>
>
>
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://www.diy-efi.org/mailman/listinfo/diy_efi
>
>



_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi