expansion of fuel/air mixture

Camden Lindsay cjl169 at hotmail.com
Sat Mar 2 08:07:25 GMT 2002


>Yep, there is a reasonably accurate way, but it's not a short way !
>
>You need to calculate your way around the cycle, and figure out what you
>have left at BDC . To ballpark it, with an NA engine, at sea level, and at
>WOT, the number will likely be somewhere between 50 and 90 psia (ABSOLUTE)
>at (or near) BDC when the exhaust valve opens.

hmm... would a integral of some function apply to this?
I am working on a boosted car, although the N/A function should be 
considered for initial spool-up.

thanks Greg!
Camden

>
>Greg
>
> >
> >
> >
> >
> >
> >>Better define what you are talking about better.
> >
> >
> >>
> >>For instance, at ignition, there is (ideally) no expansion beccause the
> >>combustion chamber doesn't allow it--so there is a rise in temperature 
>and
> >>a consequent rise in pressure. The rise in temp is determined by the 
>heat
> >>of combustion available and the mass and specific heat of the gas 
>present.
> >>The rise in pressure is then determined by the gas law.
> >>
> >>Greg
> >>
> >
> >
> >_________________________________________________________________
> >Send and receive Hotmail on your mobile device: http://mobile.msn.com
> >
> >----- End of forwarded message from owner-diy_efi at diy-efi.org -----
> >----------------------------------------------------------------------------
> >To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the 
>quotes)
> >in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>
>----- End of forwarded message from owner-diy_efi at diy-efi.org -----
>----------------------------------------------------------------------------
>To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the 
>quotes)
>in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>


_________________________________________________________________
MSN Photos is the easiest way to share and print your photos: 
http://photos.msn.com/support/worldwide.aspx

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org



More information about the Diy_efi mailing list