over-bored MAF calibration

[romans, mark]

Raise the fuel pressure.
Mark

----- Original Message -----
From: "Tom Cheung" <tcheung at associated-labels.com>
To: <diy_efi at diy-efi.org>
Sent: Tuesday, February 26, 2002 1:27 PM
Subject: over-bored MAF calibration


> i recently bored out my MAF hotwire type for my suzuki swift gti
> it seems now to run a bit on the lean side
>
> anyone know what the best way to correct this
>
> i am guessing the calibration is off now that the bore is larger than the
> sampling tube/track
>
> should i try to increase the voltage coming from the sensor? how could i
do
> this
> (the sensor itself has hitachi on it0
> or try to reshape the MAF sampling track
>
>
> Tom
>
> ----- End of forwarded message from owner-diy_efi at diy-efi.org -----
> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org