DIY-WB & Dataq 194?

[rr]

I would parallel the DIY-WB output resistor (R15) with a 10 ohm 1/4w
resistor. You will lose the level of protection that the resistor provided. It
may be a reasonable tradeoff.

BobR.


Brian Renegar wrote:

> I will be using a Dataq 194 starter kit to log the DIY-WB
> (http://www.dataq.com/products/startkit/di194.htm).  I called Dataq today,
> and asked them about the input impedance of the device.  The guy said it
> was only around 10K.  Is this sufficient for the DIY-WB?  Or do I need to
> take extra steps to ensure good readings?
>
> Thanks,
> Brian
>

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org