PC Board for WB02 36 LED bar graph display

[rr]

The writeup didn't make it to the projects page. However, it may
be found on incoming as: WB-DISP.ZIP

We will also be updating the www.diy-wb.org site with information
as it becomes available.

BobR.


Crescent Kao wrote:

> Can anyone provide more literature on this display including pics? Thanks.
>
> Crescent Kao
> Director of Marketing and Sales
> www.c-speedracing.com
>
> ----- Original Message -----
> From: <bcroe at juno.com>
> To: <diy_efi at diy-efi.org>
> Sent: Wednesday, March 06, 2002 4:51 PM
> Subject: PC Board for WB02 36 LED bar graph display
>
> > The bare PC boards for the WB 36 LED bar graph
> > display seem to be fine.  These use the parts list from
> > the diy web site, not included.  I like connectors, so the
> > board will accept a PC 15 pin male D-Sub connector;
> > I'd recommend a right angle type like
> > AMP 747841-4, Dig*Key part no  A23281-ND, $2.13.
> > Don't forget a mate for your cable, and a heat sink
> > for the voltage regulator.
> >
> > Maybe someone who gets one working can throw a
> > picture up for us.
> >
> > I have about 30 of these to spare; I can slip one in an
> > envelope to USA address, with documentation, if you
> > send me $15.  I can get more later; price might vary.
> >
> > Bruce Roe
> > 2375 Parkview Av
> > Aurora, IL 60504-9779
> >
> > On Sat, 2 Mar 2002 12:40:26 -0600 bcroe at juno.com writes:
> > > I am expecting several dozen PC boards for the WB LED
> > > display, middle of next week.  After I test a couple, the rest
> > > of the bare boards will become available.
> >
> > >  A few parts have been swapped around to optimize
> > > small size, looks like 2.2" x 4.3".
> >
> > > Bruce Roe
> >

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org