[Diy_efi] Newbie with a simplified Motronic project
Adam Wade
espresso_doppio at yahoo.com
Mon Nov 4 18:37:49 GMT 2002
--- Bevan Weiss <kaizen__ at hotmail.com> wrote:
> I'm not sure of where you can obtain a stable metal.
I am under the impression that some alloys of titanuim
are extremely stable of a great range of temperatures
and time.
If I am not mistaken, the hot wire used in a number of
MAF sensors is a titanium alloy element.
Looks like a lot of them use a zirconia element, which
I think is even more stable. I'm not even sure what
it really is, structurally; I've seen references to
ceramic, but that's not very descriptive. Still, it
would seem that MAF sensors are incredibly stable over
time and age, and a wide heat range.
I'd be far more worried about the air intake temp
sensor, or a dirty TPS, myself.
=====
| Adam Wade 1990 Kwak Zephyr 550 (Daphne) |
| http://y42.photos.yahoo.com/bc/espresso_doppio/lst?.dir=/ |
| "It was like an emergency ward after a great catastrophe; it |
| didn't matter what race or class the victims belonged to. |
| They were all given the same miracle drug, which was coffee. |
| The catastrophe in this case, of course, was that the sun |
| had come up again." -Kurt Vonnegut |
__________________________________________________
Do you Yahoo!?
HotJobs - Search new jobs daily now
http://hotjobs.yahoo.com/
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi
More information about the Diy_efi
mailing list