[Diy_efi] Accel DFI Conversion from Lt-1

[Steve Hutson]

Hey All,

I have a gen 6 (old) Accel DFI for LT-1 and would like to convert it back to
HEI CC Dist. The card has been modified to accept the 5v hall effect (Pull
to ground?) signal coming from the Optijunk. There are 3 trace cuts and 3
jumper wires. The late HEI is a 5v square wave and has its own voltage
regulator. I need to know if (best a helpful person can tell) the traces on
a L98 version are left intact. Also, if there are ANY jumper wires on that
version that I will need to add. For some reason (oversite) I cannot find a
trace from pin 'P2B2' going anywhere other than the filter cap (ground).
This makes me assume that there will need at least one added jumper. I will
record the mods as they are, in case anyone wants to convert theirs at a
later time... or better yet, does anyone have a working L98 version that
they would like to trade?

Thanks for any help,
Steve


_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi