[Diy_efi] OT: torque question for the ME types
Greg Hermann
bearbvd at mindspring.com
Fri Apr 4 03:25:52 GMT 2003
At 9:42 PM 4/3/03, Allyn wrote:
>
>can the A2 (stainless) bolts be sufficient for this task?
>perhaps the bolts i purchased are much stronger than they should be?
>is there something that i am overlooking?
>
>thanks for any assistance
>Al Malventano, ETC(SS), USN
>
Al--
Are these bolts screwed into the alloy or do they pass all the way through
the alloy into a nut of the same material as the bolt ??
Watch out for stripping/galling/pull-out if the bolts are screwed into
alloy material.
Greg
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi
More information about the Diy_efi
mailing list