[Diy_efi] vortec FP blockoff plate?

Djfreggens at aol.com Djfreggens at aol.com
Wed Jun 18 04:35:28 GMT 2003


--===============66315713523234576==
Content-Type: multipart/alternative;
	boundary="part1_1a6.16531975.2c2143f9_boundary"


--part1_1a6.16531975.2c2143f9_boundary
Content-Type: text/plain; charset="US-ASCII"
Content-Transfer-Encoding: 7bit

In a message dated 6/18/2003 12:20:45 AM Eastern Daylight Time, 
sravet at arm.com writes:


> Does anyone know if it uses a fuel pump blockoff plate
> (SBC vortec, '96-'98)?  The manual shows one, but I don't have it or any
> matching bolts in my "box of parts from taking the motor apart

is there a machined casting on the drivers side of the block above the oil 
pan on the front of engine ?? if not then no you motor doesnt use a block off 
plate.

--part1_1a6.16531975.2c2143f9_boundary
Content-Type: text/html; charset="US-ASCII"
Content-Transfer-Encoding: quoted-printable

<HTML><FONT FACE=3Darial,helvetica><FONT  SIZE=3D2>In a message dated 6/18/2=
003 12:20:45 AM Eastern Daylight Time, sravet at arm.com writes:<BR>
<BR>
<BR>
<BLOCKQUOTE TYPE=3DCITE style=3D"BORDER-LEFT: #0000ff 2px solid; MARGIN-LEFT=
: 5px; MARGIN-RIGHT: 0px; PADDING-LEFT: 5px">Does anyone know if it uses a f=
uel pump blockoff plate<BR>
(SBC vortec, '96-'98)?&nbsp; The manual shows one, but I don't have it or an=
y<BR>
matching bolts in my "box of parts from taking the motor apart</BLOCKQUOTE><=
BR>
<BR>
is there a machined casting on the drivers side of the block above the oil p=
an on the front of engine ?? if not then no you motor doesnt use a block off=
 plate.</FONT></HTML>

--part1_1a6.16531975.2c2143f9_boundary--


--===============66315713523234576==
Content-Type: text/plain; charset="us-ascii"
MIME-Version: 1.0
Content-Transfer-Encoding: 7bit

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi

--===============66315713523234576==--



More information about the Diy_efi mailing list