[Diy_efi] Looking for MAP sensors

[Perry Harrington]

Justin,

Look at the www.diy-efi.org site in the emecm area.  The part number for the GM 3 bar MAP
sensor is listed.

--Perry

On Tue, May 06, 2003 at 05:15:05PM -0400, Justin Starkey @ VMP wrote:
> I'm looking for some multibar MAP sensors that output on a 0-5v scale, for logging boost,
> vac would be nice too.  Reading up to ~30psi would be nice.
> Any suggestions?
> 
> I've got an input on my factory ecu that I can use to log, and my fjo wideband has 0-5v
> input.
> 
> FJO carries them, but they are very pricey at $70-80.  I've seen some on ebay too for $50.
> Both may be GM sensors.
> 
> Thanks
> Justin Starkey
> www.VelocityMustangPerformance.com

-- 
Perry Harrington			Data Acquisition & Instrumentation, Inc	
perry at dainst dot com					 http://www.dainst.com/

Those who would give up essential liberty to purchase a little temporary safety
deserve neither liberty or safety. Nor, are they likely to end up with either.
                             -- Benjamin Franklin

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi