[Diy_efi] Fuel rail fabrication

[bcroe at juno.com]

Get the Seville intake manifold and use it for a model; Olds 
big and small block heads have the same spacing.  However, 
other injectors may not interchange.   

These injectors were set at a couple different angles; none 
of this lining up like soldiers.  Maybe Olds knew something.  
Bruce Roe

8 Nov 03 "Chris Carson" <ccarson2 at prodigy.net> writes:
> I'm not planning on using peak-and hold injectors, I'd rather go for 
> high resistence 

> What do I have to do to the cadillac rails to make them fit? 
> Might be complex making a jig/template to drill the manifold 
> with, though...The injectors have to be right on the dot with 
> the fuel rail, right?   Can't be 1/16 inch off or bad things happen??
> Chris
_______________________________________________
diy_efi mailing list
diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi