[Diy_efi] HALF SHAFTS (CV) AXLES
RAYMOND CROSBY
rlcrosby34 at hotmail.com
Tue Mar 30 04:41:00 GMT 2004
DIFFICULTY IN REMOVING THE SPLINED HUB END ON A 1995 FORD PROBE GT. DEALER
SAID A HUB PULLER IN REVERSE (PUSHING WITH THE CENTER BOLT) OR AN AIR
CHISLE WITH A POINTED BIT NIETHER WORKED NOR DID THE TORCH! ANY HISTORY OR
ANY IDEAS OTHER THAN REMOVING ABS SENSOR AND UPPER SPINDLE TO STRUT BOLTS
AND PULLING ENTIRE HUB WITH AXLE THEN USING A PRESS?
_________________________________________________________________
Get reliable access on MSN 9 Dial-up. 3 months for the price of 1!
(Limited-time offer)
http://join.msn.com/?page=dept/dialup&pgmarket=en-us&ST=1/go/onm00200361ave/direct/01/
_______________________________________________
diy_efi mailing list
diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi
More information about the Diy_efi
mailing list