[Diy_efi] adaptor plate for GM tbi to Toyota 2F

[Jann]

Try this for Land Cruiser to Chevy adapters.
http://www.tlc4x4.com/2000/Parts/tlc_bellhsg.htm

Are you sure the transmission, transfer case, and rear end will hold up to
the additional power ?  You might want to limit yourself to a 4.3 TBI


And here for ECU locations.

S-10/s-15 '84-'94 Under Dash (Passenger Side) 
S-10/S-15 '95-'97 Passenger Side Under Hood, Corner of Firewall
Bronco II, Explorer, '87-'95 Behind Passenger Side Kick Panel

Good Luck,
Duane


-----Original Message-----
From: diy_efi-bounces at diy-efi.org [mailto:diy_efi-bounces at diy-efi.org] On
Behalf Of Dan Sawyer
Sent: Sunday, August 14, 2005 3:27 PM
To: diy_efi at diy-efi.org
Subject: [Diy_efi] adaptor plate for GM tbi to Toyota 2F 

All,

I am pulling together the parts to convert a Toyota LC 2F to GM TBI. 
This looks like a straight forward conversion. It was popular several 
years back and there were several options for the adapter. However most 
of those seemed to have stopped offering adapters. Does anyone know of a 
source for those adapters?

The next question is really simple - where in a GM S10 or Bronco is the 
ECM mounted? I had a chance to look at several yesterday, however it was 
about 95 and not pleasant to be exploring through broken glass.

Thanks in advance.

Dan
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi