[Diy_efi] Toyota 2F - TBI Install

[Lee M. Lemoine]

Someone beat me to the oil pressure switch!   Try wiring some power to
your fuel pump with an 'override' switch.  so that it always gets
power when hte car is on -- that would be my first priority...

On 8/23/05, Facundo Lozano Ureta <flozano at twistedandes.com> wrote:
> I don't have Oil pressure switch
> 
> ----- Original Message -----
> From: "Robert W Hughes" <rwhughe at oplink.net>
> To: <diy_efi at diy-efi.org>
> Sent: Tuesday, August 23, 2005 10:50 AM
> Subject: Re: [Diy_efi] Toyota 2F - TBI Install
> 
> 
> >> This is my first post on this list.
> >> I have a Toyota Land Cruiser FJ60 with 2F engine. I'm installing a TBI
> >> system from 4.3 V6 GM TBI.
> >> at list i have installed an adapter plate, Fuel pump, GM HEI with 7 pin
> >> module, 1227747 ECM with reprogramed CHIP for 2F, O2, Water Temp.
> >> I don' have VSS for the moment.
> >> When I crank, the injectors start, and the engine start for about 5
> >> seconds and stop, some times for 30 seconds, but nothing more.
> >> anyone have an idea?
> >
> > did you wire up the complete GM fuel pump circuit including the oil
> > pressure switch? A lot of the GM ECMs turn the pump on for a few seconds
> > at key on and then rely on the oil pressure switch to turn the pump back
> > on and keep it running.
> > --
> > Robert W. Hughes (Bob)
> > BackYard Engineering
> > 29:40.237N, 95:28.726W or perhaps 30:55.265N, 95:20.590W
> > Houston, Texas "The city with too much Oxygen"
> > rwhughe at oplink.net
> > _______________________________________________
> > Diy_efi mailing list
> > Diy_efi at diy-efi.org
> > http://lists.diy-efi.org/mailman/listinfo/diy_efi
> >
> 
> 
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/diy_efi
> 


-- 
Sincerely,

Lee M. Lemoine
http://www.turbochargedsoul.com/