[Diy_efi] OT : mounting fastners

Ulmer, James D - Denver, CO james.d.ulmer
Fri Dec 30 03:30:38 UTC 2005


?" mounting hole should be about a 3/8" rivnut. Readily available and not too difficult to install. My standard Rivnut tool goes to 3/8

 

Big Jim

 

-----Original Message-----
From: diy_efi-bounces at diy-efi.org [mailto:diy_efi-bounces at diy-efi.org] On Behalf Of Ernest Buckler
Sent: Thursday, December 29, 2005 7:35 PM
To: diy_efi at diy-efi.org
Subject: Re: [Diy_efi] OT : mounting fastners

 

Top reply: Depends on what you want to do with these holes?  Merely plug them up for water reasons?  Or attach something in those locations?  Rivnuts in 1/2" size are gonna be rare and hard to install.  Epoxy sounds like the best cheap answer so far.

Ernie

 

Hello all, got a question about mounting to the floor pan. Ive a new console to mount to the floor of the car... there are 2 holes - 1/2" diameter already in the floor pan does anyone know a way to put a fastner in there without getting to the back side... its kind of a pocket in the body floor. 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.diy-efi.org/pipermail/diy_efi/attachments/20051229/c8216456/attachment.html 



More information about the Diy_efi mailing list