[Diy_efi] [ot] Specs for UniPoint "ALT-V004" Uni0506 ?

[Mike]

Hi chaps,

(As its so quiet...)  I recently won this auction for a combo alternator
and vacuum pump:-
http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&ih=009&item=190012098484

Took off the vacuum pump and have a splined shaft about 1.5" long  so I
can attach a power steering pump to. The alternator side is 12v 95A
and has the usual three connections:-

1.      Output to battery (A nice hefty bolt)
2.      A 2 pin plug on the side which must be regulator input and
        the drive for the charge fail light. Looks like a Bosch type
        temp sensor or injector type plug and easy to attach.

The alternator P/N is  "ALT-V004" and "UNI0506"    I've sent an email off
to Unipoint to request specs but as they are in Taiwan, not sure when I'll
get a reply,

So I'm curious if anyone is familiar with this model and/or has specs on it,
such as identifying which pin on the 2 pin connector is what and whether
the drive to the charge fail light is active low (pull from 12v) or source etc ?

btw: The cast supports for the vacuum pump I took off look quite strong and
when I have machined a plate they should take a power steering pump, so
at long last I will be able to move the old one from the other side of the
engine along with its heavy support bracket, bit of messing around with
pipes but hey, thats par for the course :)




Regards from


Mike
Perth, Western Australia
VL Commodore Fuse Rail that wont warp or melt !
Twin tyres for most sedans, trikes and motorcycle sidecars
http://niche.iinet.net.au