[Diy_efi] Source for inexpensive fuel/oil pressure sensors?

[David Allen]

  I know nothing of the Chrysler transmission; however Delco makes a 
stand-alone transmission controler with LOTS of parameters. It's the16128420 
transmission ECM. Natively used to control a 4L80E in diesel trucks which 
have no engine ECM. I think it may be limited to 4-speeds (or less) with TCC 
clutch.
  It is OEM hardware (read-well built) and is supported by TunerCAT and uses 
a socketed EPROM and can be real-time tuned with an emulator. Also 
diagnostics supported by many scan tools including EASE and Snap-On.
  No idea what sort of interface adapter hardware would need to be created 
to allow it to work with a non-native tranny.  I'm fixing to jump in 
head-first and setup a stand-alone 4T65E based on it.  Will be fun!
  Later,
David

>
> Is that trans the front drive transaxle for the Concord ?  That transaxle 
> is
> the most compact I've seen and wondered could you run it with just  a 
> trans
> module or does it run from the car
> PCM ?