[Diy_efi] Cleaning a wire harness?

[Bill USN-1]

If you have it on the ground, use a 50/50 mix of castrol superclean and
water. Use a paintbrush to scrub it. 

Or if you want to wipe 1 wire at a time, I used to use lacquer thinner.

Bill
USN-1


-----Original Message-----
From: diy_efi-bounces at diy-efi.org [mailto:diy_efi-bounces at diy-efi.org] On
Behalf Of Mike
Sent: Monday, October 09, 2006 8:42 AM
To: diy_efi at diy-efi.org
Subject: [Diy_efi] Cleaning a wire harness?

Hi
Does anyone have a good way of cleaning a wire harness without damaging the
wire and connectors. I don't want to use harsh chemicals or solvents on my
harness but I would like to clean it, remove unused wires, then retape and
replace the split loom.
The harness is from a 91 GM Full size Van.

Thanks

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
Subscribe: http://lists.diy-efi.org/mailman/listinfo/diy_efi
Main WWW page:  http://www.diy-efi.org/diy_efi