[Diy_efi] Re: 10k resistor modification

[Rich Rubel]

Thank you.  I'll try it again; maybe it wasn't making contact right  
in the socket.
[RICHR]

On Oct 14, 2006, at 13:00, diy_efi-request at diy-efi.org wrote:

> What you are doing is enabling the high speed data mode on the  
> computer.
> The 10K resistor does go between A and B (these are the same two pins
> you short to get trouble codes) leave your hardwired serial cable  
> as is,
> and add the resistor.
>
> Now my experience is the resistor is only needed to get it started  
> after
> that data will continue till you disconnect power down ECM.  This
> happened to me last week.  I was data logging a 1989 TPI setup and  
> data
> was doing fine and I noticed my resistor popped out, but it was still
> running.