[Bulk] Re: [Diy_efi] Donegan ECU

[Steven Donegan]

At the moment the daughter board is just the HV power supply and the current mirrors - ie the signal aquisition part of things. Many folks out there in engineering space have used relatively low speed microcontrollers and PC's to do the actual signal reduction - I will start as they have and work my way up to the required processor - which may very well be a DSP.

Adam Wade <espresso_doppio at yahoo.com> wrote: --- "Steven P. Donegan"  wrote:

> Closed loop, per cylinder timing and combustion
> efficiency as well as knock detect are all goals
> of my Ion subsystem...

VERY nice.  You going to use a DSP chip on the
daughterboard?  I understand that FFT is the best way
to get useful data from the signal...

| Kawasaki Zephyr 615 (Daphne)       Kawasaki Zephyr 550 (Velma)|
| "It was like an emergency ward after a great catastrophe; it  |
|   didn't matter what race or class the victims belonged to.   |
|  They were all given the same miracle drug, which was coffee. |
|   The catastrophe in this case, of course, was that the sun   |
|     had come up again."                    -Kurt Vonnegut     |
| M/C Fuel Inj. Hndbk. @ Amazon.com -  http://tinyurl.com/6o3ze |

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
Subscribe: http://lists.diy-efi.org/mailman/listinfo/diy_efi
Main WWW page:  http://www.diy-efi.org/diy_efi