[Diy_efi] Warning this is hard to follow

[Mike Yates]

www.legacyengine.com


On Fri, 08 Jun 2007 11:18:20 -0700, you wrote:

>Innovative but less than practical from a manufacturing
>standpoint...plus the ports seem to work via magic and not
>physics....intake port overlap is bad and exhaust port is way too
>small to support any RPM...afaict.
>
>Mike
>
>
>On Thu, 7 Jun 2007 15:24:18 EDT, you wrote:
>
>> 
>>In a message dated 07/06/2007 19:05:52 GMT Standard Time,  b.shaw at comcast.net 
>>writes:
>>
>>http://www.aviationweek.com/media/flash/legacyanimation.mov
>>
>>
>>
>>Good grief, I can't begin to imagine the tip and side rotor seal  problems.  
>>It really puts the Wankel in the shade.  I'll stick my neck  out and say it 
>>will never make it out o fthe lab and into production.
>> 
>>Will C
>>
>>
>>
>>   
>>_______________________________________________
>>Diy_efi mailing list
>>Diy_efi at diy-efi.org
>>Subscribe: http://lists.diy-efi.org/mailman/listinfo/diy_efi
>>Main WWW page:  http://www.diy-efi.org/diy_efi
>
>_______________________________________________
>Diy_efi mailing list
>Diy_efi at diy-efi.org
>Subscribe: http://lists.diy-efi.org/mailman/listinfo/diy_efi
>Main WWW page:  http://www.diy-efi.org/diy_efi