[Diy_efi] F CRIMP FOR OPEN BARREL TERMINALS
Thu Feb 23 02:20:50 UTC 2012
I've always just crimped twice.
Once on the terminal, once on the insulation.
Something like this ...
And I didn't know this stuff.
From: diy_efi-bounces at diy-efi.org [mailto:diy_efi-bounces at diy-efi.org] On
Behalf Of Hugh Keir
Sent: Wednesday, February 22, 2012 3:27 PM
To: diy_efi at diy-efi.org
Subject: [Diy_efi] (no subject)
I am looking for a low cost crimp tool for prototyping for the AMP
3-1447221-3 Superseal crimp connector attached.
The superseal connector is commonly used on the likes of Motec ECU
Ideally the crimp tool would crimp the wire and the sheath in one action.
More information about the Diy_efi